Decal Kits

Personalise your MX Bike with 24MX Decal Kits

Motocross bikes don't have conventional-shaped steel fuel tanks, side panels or mudguards. Instead, all the components are plastic and minimalistic with angular lines. They do, though, have a few flat surfaces. Flamboyant motocross graphics are often bike decals rather than a conventional paint scheme. A decal kit is a set of motorbike graphics designed to fit different body parts of an MX bike. Whether you race or ride on the dirt for pleasure, parts of a motocross bike will get scuffed or damaged by the rider's boots, stones and dirt or from a drop. At the end of a season, your bike will look more than a little beaten up! The good news is that rebuild time also allows you to update your motorbike graphics.

Exact fit

Each motocross graphics kit in the 24MX range is precision cut to fit the make and model of your bike. The graphics are digitally printed and the finished product is laminated in a hard-wearing plastic coating. When the process is complete, the back of the decals receives a specialised glue. Its adhesion is impressive, yet it leaves no residue when removed. The result is pin-sharp graphics finished in a tough, wear-resistant gloss finish for that fresh-from-the-factory look.

Easy process

Thanks to 24MX, you can elevate motocross graphics from factory fresh to works racer with a personalised decal set. This process allows you to individualise your bike by adding your name and race number to its number plates. The process couldn't be any easier. First, choose your decal set. Then select your bike's make, model and year from the drop-down menus. Once complete, there are two other boxes. Here is where you enter your name and race number. With almost 100 colour and design options, it is one of the most cost-effective, easy ways to elevate your motorcycle's look.

If you haven't undertaken this kind of project before, no stress; it's a hassle-free job. First, remove the old decals. Then clean the plastic using an adhesive removal spray. When clean, position the decals with masking tape before slowly pulling away the backing. If you want to view the process step by step, check out the 24MX helpful instruction video. You'll find it within the product description. 24MX motocross graphics kits have decals to fit many components. These include radiator wings, tank, front fender, rear fender, fork guard, air can, swing arm and number plates. These kits upgrade your dirt bike's look at a fraction of the cost of a re-spray.